quantitative extraction of asphalt binder from hot mix

Quantitative Extraction of Asphalt Binder from Hot Mix ...

Quantitative Extraction of Asphalt Binder from Hot Mix Asphalt (HMA) Reference AASHTO T 164-14 (2018) (ASTM D 2172 / D 2172M-11) AASHTO Section Illinois Modification 10.1 Replace with the following: When required, calculate the moisture content of the mixture. Moisture content in the sample is defined as follows: Original Mass Oven Dry Mass

get price

Quantitative evaluation of asphalt binder extraction from ...

Mar 01, 2021  1. Introduction. Asphalt binder extraction from hot mix asphalt (HMA) pavement mixes has not been sufficiently addressed in literature [1, 2].In compliance with Burr et al. (1993), the binder extraction methods still need further research to deliver a good accuracy (measurements proximity to the actual value) and precision (the degree to show the same results of repeated measurements under no ...

get price

Quantitative Evaluation of Asphalt Binder Extraction from ...

Oct 05, 2020  Quantitative Evaluation of Asphalt Binder Extraction from Hot Mix Asphalt Pavement Using Ashing and Centrifuge Methods Ahmed Hemida Ph.D. Candidate, Department of Civil, Architectural and Environmental Engineering Missouri University of Science and Technology, Rolla, MO 65409 Email: [email protected] Magdy Abdelrahman, Ph.D.

get price

(PDF) Quantitative Evaluation of Asphalt Binder Extraction ...

Preprints (preprints) NOT PEER-REVIEWED Posted: 5 October 2020 Quantitative Evaluation of Asphalt Binder Extraction from Hot Mix Asphalt Pavement Using Ashing and Centrifuge Methods Ahmed Hemida Ph.D. Candidate, Department of Civil, Architectural and Environmental Engineering Missouri University of Science and Technology, Rolla, MO 65409 Email:

get price

(PDF) Quantitative evaluation of asphalt binder extraction ...

Asphalt binder extraction from hot mix asphalt (HMA) pavement The outcomes of extraction methods are still not reproducible to mixes has not been sufficiently addressed in literature [1, 2].

get price

(PDF) Quantitative evaluation of asphalt binder extraction ...

Quantitative evaluation of asphalt binder extraction from hot mix asphalt pavement using ashing and centrifuge methods March 2021 Transportation Engineering 3:100046

get price

(PDF) Quantitative Evaluation of Asphalt Binder Extraction ...

Preprints (preprints) NOT PEER-REVIEWED Posted: 5 October 2020 Quantitative Evaluation of Asphalt Binder Extraction from Hot Mix Asphalt Pavement Using Ashing and Centrifuge Methods Ahmed Hemida Ph.D. Candidate, Department of Civil, Architectural and Environmental Engineering Missouri University of Science and Technology, Rolla, MO 65409 Email:

get price

(PDF) Quantitative evaluation of asphalt binder extraction ...

Quantitative evaluation of asphalt binder extraction from hot mix asphalt pavement using ashing and centrifuge methods March 2021 Transportation Engineering 3:100046

get price

"Quantitative Evaluation of Asphalt Binder Extraction from ...

Jan 19, 2021  Asphalt binder requires more investigation to be accurately and precisely extracted since it is an effective procedure for quality assurance quality control (QA/QC) and subsequent binder characterization. In this research, the authors presented a hands-on experience with binder extraction to deliver recommendations concerning the sensitive steps that may affect the outcomes (extracted binder ...

get price

Standard Test Method for Quantitative Extraction and ...

1. Scope. 1.1 This test method covers a procedure for the extraction and recovery of asphalt binder from asphalt mixtures-both HMA (hot mix asphalt) and RAP (reclaimed/recycled asphalt pavement)—having a minimal effect on the physical properties of the asphalt binder recovered.

get price

AASHTO T 164 : Standard Method of Test for Quantitative ...

AASHTO T 164, 2014 Edition, 2014 - Standard Method of Test for Quantitative Extraction of Asphalt Binder from Hot Mix Asphalt (HMA) These methods cover the quantitative determination of asphalt binder in hot mix asphalt (HMA) and HMA pavement samples. Aggregate obtained by these methods may be used for sieve analysis using T 30.

get price

Standard Method of Test for Quantitative Extraction of ...

Jan 01, 2014  These methods cover the quantitative determination of asphalt binder in hot mix asphalt (HMA) and HMA pavement samples. Aggregate obtained by these methods may be used for sieve analysis using T 30. The values stated in SI units are to be regarded as the standard. This standard may involve hazardous materials, operations, and equipment.

get price

INDIANA DEPARTMENT OF TRANSPORTATION DIVISION OF

T 164 Quantitative Extraction of Asphalt Binder from Hot Mix Asphalt (HMA) 2.2 ITM Standards. 572 Dying HMA Mixtures . 580 Sampling HMA . 587 Reducing HMA Samples to Test Size . 2.3 ASTM Standards. D8159 Automated Extraction of Asphalt Binder from Asphalt Mixtures . 3.0 TERMINOLOGY. Definitions for terms and abbreviations shall be in accordance ...

get price

DIME - Sample Record for DIME Sample ID 2021-05-15-3

May 15, 2021  AASHTO T164-14: Standard Method of Test for Quantitative Extraction of Asphalt Binder from Hot Mix Asphalt (HMA) (Asphalt Binder Content) Kleinfelder: Granite Construction - Coastal: 05/15/2021: Yanlong Liang

get price

Binder Content – Pavement Interactive

Solvent extraction methods (described in AASHTO T 164 and ASTM D 2172) use a solvent to remove asphalt binder from aggregate in an HMA mixture. Asphalt binder content is then calculated by subtracting the mass of the aggregate remaining after the asphalt binder is removed from the initial mass of the test sample.

get price

866 Asphalt Mixture Design

Determination of Draindown for Uncompacted Asphalt Mixtures AASHTO T305 Quantitative Extraction of Asphalt Binder from Hot Mix Asphalt (HMA)[1] AASHTO T164 M th d A B Asphalt Content by Ignition Oven[2] WisDOT modified AASHTO T308 Asphalt Content by Automated Extraction[1] WisDOT modified ASTM D8159 [1] Not required as part of the mix design ...

get price

Centrifuge Binder Extractors - GROUNDTEST EQUIPMENT

Gilson’s popular Centrifuge Extractors provide efficient and reliable quantitative determinations of bitumen content in hot-mix asphalt specimens. Rotation speeds up to 3,600rpm are easily set using the speed control knob. The built-in electric brake stops the centrifuge in seconds when extraction

get price

MARSHALL MIX DESIGN METHOD FOR ASPHALTIC

Asphalt Binder AASHTO R 29 Grading or Verifying the Performance Grade of an . Asphalt Binder AASHTO T 96 Resistance to Degradation of Small-Size Coarse Aggregate by Abrasion and Impact in the . Los Angeles Machine AASHTO T 164 Quantitative Extraction of Asphalt Binder from Hot-Mix Asphalt (HMA) – Method A

get price

AASHTO T 164-13

These methods cover the quantitative determination of asphalt binder in hot mix asphalt (HMA)and HMA pavement samples. Aggregate obtained by these methods may be used for sieveanalysis using T 30. Details Published: 2013 Number of Pages: 21 File Size: 1 file , 3.2 MB

get price

Bitumen Asphalt Extraction - Asphalt Hot Mix Bitumen

The asphalt binder/solvent and aggregate are then separated using a centrifuge (see Figures 7 and 8) and the aggregate is weighed. The initial and final weights are compared and the difference is assumed to be the asphalt binder weight. Using this weight and the weight of the original sample a percent asphalt binder by weight can be calculated.

get price

Standard Test Method for Quantitative Extraction and ...

1. Scope. 1.1 This test method covers a procedure for the extraction and recovery of asphalt binder from asphalt mixtures-both HMA (hot mix asphalt) and RAP (reclaimed/recycled asphalt pavement)—having a minimal effect on the physical properties of the asphalt binder recovered.

get price

METHOD OF TEST FOR QUANTITATIVE EXTRACTION OF

2.1 AASHTO T 164 Standard Method of Test for Quantitative Extraction of Asphalt Binder from Hot-Mix Asphalt (HMA) 2.2 ASTM C702 Standard Practice for Reducing Samples of Aggregate to Testing Size 2.3 ASTM D2172 Standard Test Methods for Quantitative Extraction

get price

"Quantitative Evaluation of Asphalt Binder Extraction from ...

Such cores involved reclaimed asphalt pavement (RAP), reclaimed asphalt shingles (RAS), and a wide range of additives. The two extraction methods were compared with concluding that the centrifuge method was highly recommended based on a quantitative evaluation, which delivered the same average Pba % based on the 38 cores.

get price

DIME - Sample Record for DIME Sample ID 2021-05-15-3

May 15, 2021  AASHTO T164-14: Standard Method of Test for Quantitative Extraction of Asphalt Binder from Hot Mix Asphalt (HMA) (Asphalt Binder Content) Kleinfelder: Granite Construction - Coastal: 05/15/2021: Yanlong Liang

get price

WSDOT SOP 737

Asphalt Binder Content of Hot Mix Asphalt by the Ignition Method”, if an ignition furnace correction factor (IFCF) is available. Otherwise, perform AASHTO T 164, “Standard Method of Test for Quantitative Extraction of Asphalt Binder from Hot Mix Asphalt”. 7.5

get price

MARSHALL MIX DESIGN METHOD FOR ASPHALTIC

Asphalt Binder AASHTO R 29 Grading or Verifying the Performance Grade of an . Asphalt Binder AASHTO T 96 Resistance to Degradation of Small-Size Coarse Aggregate by Abrasion and Impact in the . Los Angeles Machine AASHTO T 164 Quantitative Extraction of Asphalt Binder from Hot-Mix Asphalt (HMA) – Method A

get price

Binder Content – Pavement Interactive

Solvent extraction methods (described in AASHTO T 164 and ASTM D 2172) use a solvent to remove asphalt binder from aggregate in an HMA mixture. Asphalt binder content is then calculated by subtracting the mass of the aggregate remaining after the asphalt binder is removed from the initial mass of the test sample.

get price

STONE MATRIX ASPHALT SMA

AASHTO 164-14, Quantitative Extraction of Asphalt Binder from Hot Mix Asphalt (HMA) ASTM D7643-16, Standard Practice for Determining the Continuous Grading Temperatures and Continuous Grades for PG Graded Asphalt Binders AASHTO T166-16, Bulk Specific Gravity (Gmb) of Compacted Asphalt Mixtures Using Saturated Surface-Dry Specimens

get price

Bitumen Asphalt Extraction - Asphalt Hot Mix Bitumen

The asphalt binder/solvent and aggregate are then separated using a centrifuge (see Figures 7 and 8) and the aggregate is weighed. The initial and final weights are compared and the difference is assumed to be the asphalt binder weight. Using this weight and the weight of the original sample a percent asphalt binder by weight can be calculated.

get price

Centrifuge Binder Extractors - GROUNDTEST EQUIPMENT

Gilson’s popular Centrifuge Extractors provide efficient and reliable quantitative determinations of bitumen content in hot-mix asphalt specimens. Rotation speeds up to 3,600rpm are easily set using the speed control knob. The built-in electric brake stops the centrifuge in seconds when extraction

get price

AASHTO T 319 - Standard Method of Test for Quantitative ...

Jan 01, 2015  scope: This standard describes a procedure for the extraction and recovery of asphalt binder from asphalt mixtures [both hot mix asphalt (HMA) and reclaimed asphalt pavement (RAP)] that have a minimal effect on the physical and chemical properties of the asphalt binder recovered.

get price

Standard Test Methods for Quantitative Extraction of ...

Note 2: Further testing of the asphalt mixture may be performed by using sieve analysis on the extracted aggregate, Test Method D5444, or recovering the extracted asphalt binder from solution by Test Method D1856, Practice D5404/D5404M, or Practice D7906 for asphalt binder property testing. When recovering the asphalt binder for property testing, all mineral matter should be removed from the ...

get price

Characterization of Asphalt Mixtures with High Recycled ...

with respect to characterization of rejuvenated binder blends and hot mix asphalt mixtures. 2. REFERENCED DOCUMENTS 2.1 AASHTO Standards T 164, Quantitative Extraction of Asphalt Binder from Hot-Mix Asphalt (HMA) R 30, Mixture Conditioning of Hot-Mix Asphalt (HMA) T 315-12, Determining the Rheological Properties of Asphalt Binder Using a ...

get price

1. PURPOSE SCOPE

T 27 and T 11 if the laboratory is using T 308, Determining the Asphalt Binder Content of Hot Mix Asphalt (HMA) by the Ignition Method or T 164, Quantitative Extraction of Asphalt Binder from Hot Mix Asphalt (HMA). 4.2 The laboratory is required to have a

get price